Procedure Instruction of Pre-Laminating Polyvinyl Butyral PVB Interlayer Film
All rights reserved by CNC-INTERLAYER TECH:
【Product 1】CNC-Force EVA INERLAYER FOR
ARCHITECTURAL LAMINATED GLASS eva@evafilms.com
【Product 2】CNC-SmartSMART FILM FOR PRIVACY
SWITCHABLE GLASS smartfilm@smartestglass.com
【Product 3】CNC-Shield PVB INTERLAYER FOR
AUTOMOTIVE WINDSHIELD GLASS pvb@pvbfilm.net
Web: www.CNCglass.com www.CNCnext.com
www.HelloGlass.com
Mail: cnc@cncnext.com
benext77@gmail.com/
benext77@hotmail.com
www.helloglass.com
www.cncnext.com
1.
Clean the glass, better use the softened water to clean the oil, dust,
flaw on the glass surface. Then dry the glass and put away in the
laminating room.
2.
When cutting the Polyvinyl Butyral PVB interlayer film according to
the glass, make sure the Polyvinyl Butyral PVB interlayer film only
2mm extra larger than the glass, or the too much extra Polyvinyl
Butyral PVB interlayer film will seal the laminated glass before all
the Polyvinyl Butyral PVB interlayer film is totally melted. 3.
Requirement of Pre-Laminating Room for Polyvinyl Butyral PVB interlayer film
Pre-laminating room's environment is very important for manufacturing
successfully laminated glass with Polyvinyl Butyral PVB interlayer
film. There are some requirements:
+Install double doors, and the double doors not open at the same time
and better install wind-shower equipment in the middle of double
doors.
+The temperature inside the pre-laminating room should keep at 18-20
degrees and humidity at 20%-30%.
+Workers should wear antistatic suit, glove, hat.
+Regularly clean the equipments and pre-laminating room.
All rights reserved by CNC-INTERLAYER TECH:
【1】CNC-Force® EVA INERLAYER FOR ARCHITECTURAL LAMINATED GLASS
【2】CNC-Smart® SMART FILM FOR PRIVACY SWITCHABLE GLASS
【3】CNC-Shield® PVB INTERLAYER FOR AUTOMOTIVE WINDSHIELD GLASS
Mail: cnc@cncnext.com
Web: www.CNCnext.com
benext77@gmail.com/
benext77@hotmail.com
No comments:
Post a Comment